Top Four Tips to Get Your Deck Ready

 If you are planning to pressure wash your deck, make sure that you are doing it right! St. Louis Park Pressure Washing Near Me guys are the best people to help you in this activity. Note that if you fail to do it right, you will end up damaging your deck. Although this particular equipment is so powerful that it can etch even the hardest concrete in no time, if you are getting the right machine in place and hand it over to someone who can handle it appropriately, your job will get easier!

1.    Select the right pressure tip

Make sure that you are applying the right pressure setting and spray tip as well to get this work done! Use the lowest pressure that could be applicable if you are applying it on softwoods. Gradually, you may increase the pressure.But make sure that it is not going above 1200 PSI.

2.    Test the settings

Test the settings of your pressure washer and, further, its effectiveness in an inconspicuous region. Start from 500 PSI and then keep increasing it slowly until you find the right pressure setting. This would be good enough for your cleaning job.

3.    Power wash the deck

Hold the tip a little distance away from the deck surface. Next, put the wand downwards but not closer than that of 6 inches as you may end up damaging your surface otherwise. Always consider taking the assistance of the St. Louis Park Pressure Washing Near Me service provider to assist you with the same.

4.    Use the right deck cleaning solution

Consider using the right kind of deck cleaning solution when it comes to removing the stains and stubborn spots from the surface. Maybe, a solution of sodium hydroxide will help you get the job done!